The following is a brief introduction to the installation steps of the slitting machine

The following briefly explains the installation steps of slitting machine

Does the air leakage of the slitting machine affect the effect?

We know that the use of the slitting machine has a good effect on many products, and there may be air leakage. We should also observe this phenomenon and pay attention to many points. First, we will talk about whether the air leakage of the slitting machine will affect the effect. Air leakage of

slitting machine will of course affect the effect, so we need to solve this problem in time. We can think of it as a means of transportation. If the air leaks, the vehicle will be weak. If the cutter mixture is too rich or too lean, the fuel in the engine combustion chamber will not ignite, resulting in increased fuel consumption, cylinder leakage will also cause slow acceleration of the vehicle, The slitting machine will not only leak air, but also continue to have other problems, for example, if there is broken paper, first check whether the cutter head of the lower knife is too steep. If the bottom cutter head is too steep, please adjust the bottom rocker to make the bottom cutter head fall, and then start the operation.

The slitting knife of shakes. It may be that the cylinder is leaking. You can remove or repair the steel cylinder to deal with it. If there is a leak, it is recommended that you repair it immediately, because the leak affects the driving force of the car engine. At the same time, there is vibration when driving at high speed, and it is caused by abnormal noise. The engine piston is seriously damaged. The engine piston is not elastic enough or the protruding surface burns out, cause blow-by; improper installation of engine piston opening part leads to professional matching and air leakage. When

slitting machine leaks air, it will generally be affected by the above. Our machinery leaks air, which will generally affect the effect.

What are the steps to install the slitting machine?

slitting machine is a kind of high-efficiency and high-precision processing equipment, which is widely used in papermaking, printing and papermaking industries. Do you know the steps to install the slitting machine?

When the slitting machine is not installed at the beginning, the components are usually separated. After site selection, place the front and rear middle frames on the horizontal ground to maintain a unified horizontal line to maintain stable operation. After some slitting machines are installed, Turn on the power supply for debugging. During debugging, no installation materials are needed. You can test them and then observe the operation of each part. If any abnormalities are found, immediately cut off the power.

When slitting machine is not running, for safety reasons, the power supply must be disconnected. After installation, check all parts of the slitting machine, including chains, sprockets, bearings, reducers, and add lubricating oil or grease before operation. After lubrication treatment, debug the main parts to make it rotate smoothly without blocking. The site where the slitting machine is installed must be on a relatively flat hardened ground.

Well, the editor will not explain much. Well, I wish everyone a happy life and let's see you next time.